2080
Varen er på lager.
Varen er bestilt fra leverandør og leveringsdato er bekreftet.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varen må bestilles fra leverandør.
Varen befinner seg på fjernlager.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varene bestilles fra vår leverandørs lager.
Ubekreftet - Ta kontakt med kundesenter for nærmere informasjon.

 Handlevogn

Handlevognen er tom.

 

LED Beacon LED-X Single 12vDC [bk] 1:RED

Flash/Permanent IP66 Directional w/Lugs

Varenr:
LEDX012ROD
LEDX012ROD X-Diverse  LED Beacon LED-X Single 12vDC [bk] 1:RED Flash/Permanent IP66 Directional w/Lugs
LEDX012ROD X-Diverse  LED Beacon LED-X Single 12vDC [bk] 1:RED Flash/Permanent IP66 Directional w/Lugs

LED-X Single Directional LED module - Extreemly Powerfull
 
Introduction:
The Exterior LED modules are weatherproof LED based warning light modules that contain state-of-the-art high intensity LEDs. These products provide eight different operation modes including a steady-burn mode. These products may be adapted to a variety of exterior applications such as motorcycle applications, OEM fire truck, grill light and back-deck applications. The exterior LED is available in either a +12V or a +24V version.
 
Features and Specifications:
Operating Voltage: 10-16Vdc (+12V version), 22-30Vdc (+24V version),
Reverse Polarity Protection.
50% Duty Cycle unless otherwise stated.
Flash Rate: 70 fpm minimum
Flash Modes (Flashing version only):
1. Cycle-Flash: Cycles through Triple, Quad, Double, and Fast Single modes at approximately 109 fpm.
2. Triple-Flash: Three consecutive pulses per flash at approxmately 83 fpm.
3. Quad-Flash: Four consecutive pulses per flash at approximately 77 fpm.
4. Double-Flash: Two consecutive pulses per flash at approximately 78 fpm.
5. Single-Flash: Single flash pattern at 75 fpm.
6. Quad-Flash 70% Duty Cycle: Can be used for NFPA.
7. Steady-burn: Continuous ON-state operation.
Flashing Current Draw: 0,25A Avg.
Steady Burn Current Draw: 0,5A Avg.
Available colors - Red, Amber or Blue or any combination for dual modules.
Available configurations - Single or dual light heads, Amber, Red, or Blue.
 
Important Notice: Before installation, read the manual.
 
WARNING: The white wire should NOT be connected to a positive voltage under any circumstances.
This Product contains high intensity LED devices. To prevent eye damage, DO NOT stare into light beam at close range.


Copyright © 2024 Marin Supply. All rights reserved.
Forretningssystem og nettbutikkløsning levert av Multicase™ Norge AS
(4.21.3.82)